home *** CD-ROM | disk | FTP | other *** search
/ Tech Arsenal 1 / Tech Arsenal (Arsenal Computer).ISO / tek-20 / newmods9.zip / TM721A.15 < prev    next >
Text File  |  1991-12-21  |  1KB  |  42 lines

  1. TM721A.15
  2.  
  3. 73's Jim KD3O @ KD3O.MD.USA.NOAM
  4.  
  5. SB-931
  6.  
  7. TM-721A Low/No VHF Transmit Power                 4-11-88
  8.  
  9.  
  10. Some early model TM-721A transceivers may develop low or no output power on
  11. the VHF band.  This may be caused by coil L6 or L9 on the final unit.  The
  12. coils should be inspected for burn marks on their insulation.  If any flaw
  13. is detected in the insulation, replace the coild with a wider spaced coil.
  14.  
  15. Required parts:
  16.  
  17. Coil, 9.5T     L6,L9     Part Number L34-1238-05
  18.  
  19. 1.   Disconnect the power supply and antenna from the transceiver.
  20. 2.   Remove the top and bottom covers (12 screws).  Do not damage the
  21. speaker wires when removing the top cover.
  22. 3.   Remove the VHF Final unit shield (4 screws) from the top of the TM-
  23. 721A.
  24. 4.   Unsolder the Final module (Q1), antenna coax, and terminal pin W4 from
  25. the Final board.
  26. 5.   Unplug the wires at connectors CN2, CN3, and CN4 on the VHF TX-RX unit
  27. (top side of the transceiver.)
  28. 6.   Unplug the wires at connector CN10 on the UHF TX-RX unit (bottom side
  29. of the transceiver.)
  30. 7.   Remove the 7 screws from the VHF Final unit.  Remove the Final unit
  31. fromt he transceiver.
  32. 8.   Unsolder an remove the coil (L6 or L9).  Install and solder the new
  33. coil.
  34. 9.   Assemble the transceiver by reversing steps 1 - 7.
  35.  
  36.  
  37. This modification  may be performed under warranty.
  38. Time required for this change is 1 hour or less.
  39.  
  40. (c) 121589TKC
  41.  
  42.